Oster XPERT PRO Manual De Instrucciones página 17

• Due to the power of the machine, it is normal for it to be fairly loud during
operation. Through the blending cycle, the noises may change, but there is no
need to be concerned.
Ice Crushing: For optimal ice crushing, fill the jar with preferred amount of
ice. Then fill with water just above where the ice stops. Use the speed dial to
blend on High for a few seconds. Then drain out the excess water and you are
left with a jar filled with great consistent ice!
ADVA N C E D MOTOR PROTE C TION
Your blender is protected by an Advanced Motor Protection System (A.M.P.).
In the event that the unit stops working while being used:
1. Turn the knob to the "O" position and turn knob again to desired speed.
2. If unit is still not working, unplug the unit from the power source.
3. Wait for 1 to 2 minutes then press the reset switch under the unit (Fig. 1).
If the unit is still not turning on:
1. Turn the knob to the "O" position and unplug from the power source.
2. Wait 20 to 40 minutes for the unit to cool down.
S YST E M ( A. M.P.)
Figure 1
En glis h-7