cecotec BOLERO SQUAD I 3200 Manual De Instrucciones página 79

Spills on touch
icons
5. TROUBLESHOOTING
Problem
The induction hob
does not turn on
The touch icons do
not work
It is difficult to use
the touch icons
The glass is
damaged
Unplug the induction hob from the
mains.
Blot the spill.
Clean the touch control area with a
sponge or a damp and clean cloth.
Dry the area completely with a
paper towel.
Unplug the induction hob from the
mains.
Possible causes
There is no electricity.
Touch icons are locked.
There may be a slight film
of water on the icons, or
you may be using your
fingertip to press the
buttons.
Irregular-edged cookware.
Use of inappropriate and
abrasive scouring pads or
cleaning products.
The induction hob may emit an
acoustic signal and switch off, and
the icons may not work if wet. Be
sure to dry the touch icons before
switching the induction hob back
on.
Possible solution
Make sure the hob is connected to
the mains and it is on.
Check if there has been a power
failure. If the problem persists,
please contact the official Cecotec
Technical Support Service.
Unlock the touch icons. Please refer
to the instructions in the section
"Operation of the induction hob".
".
Make sure the touch icons are dry
and press them with the base of your
finger.
Use cookware with flat and smooth
bases. See section on "Choosing the
right cookware".
Read the "Cleaning and maintenance"
section.
BOLERO SQUAD I 3200
ENGLISH
79