Using the clock, kitchen timer, and control lockout.
GEAppliances.c
To Set the Clock
The clock must be set to the correct time of day
for the Delay Start functions to work properly.
The time of day cannot be changed during
a delayed cooking or a delayed self-cleaning
cycle.
Touch the CLOCKpad.
Touch the number pads until the correct
time of day is shown in the display. If the
number pads are not touched within one
minute after you touch the CLOCKpad,
the display reverts to the original setting. If
this happens, touch the CLOCKpad and
enter the time of day.
r_
Touch the STARTpad until the time of day
shows in the display.This enters the time
and starts the clock.
To check the time of day when the display is
showing other information, touch the CLOCK
pad. The time of day shows until another pad
is touched. To change the time format or turn
off the clock display, see the SpecialFeatures
section.
The KitchenTimer is in hours and
minutes.
TheKitchenTimerdoesnot controloven
operations. T hemaximum settingon the
KitchenTimeris9 hoursand 59 minutes.
To Set the Kitchen
Timer
%
[]
Touch the KITCHEN TIHER ON/OFF pad.
Touch the number pads until the amount
of time you want shows in the display. For
example, to set 2 hours and 45 minutes,
touch 2, 4 and 5 in that order. If you make
a mistake, touch the KITCHENTIMERON/
OFF pad and begin again.
[]
Touch the STARTpad.
After touching the STARTpad,SETdisappears;
this tells you the time is counting down, although
the display does not change until one minute
has passed.Seconds will not be shown in the
display until the last minute iscounting down.
r4]
When the kitchen timer reaches :00, the
control will beep 3 times followed by one
beep every 6 seconds until the KITCHEN
TIHER ON/OFF pad is touched.
The 6-second tone can be cancelled by
following the steps in the Special features of
your oven control section under Tonesat the
End of a Timed Cycle.
To Reset the Kitchen
Timer
If the display is still showing the time remaining,
you may change it by touching the KITCHEN
TIMERON/OFF pad, then touching the number
pads so that the time you want appears in the
display.
If the remaining time is not in the display (clock,
delay start or cooking time are in the display),
recall the remaining time by touching the
KITCHENTIMERON/OFF pad and then touch
the number pads to enter the new time you
want.
To Cancel the Kitchen Timer
Touch the KITCHENTIMERON/OFF pad twice.
How to Lock Out the Controls
Control Lockout will allow you to lock out the
touch pads so they cannot be activated when
touched.
To lock/unlock the controls:
[Z] Touch and hold the 9 and 0 pads at the
same time for 3 seconds. The display will
show LOCON.
To unlock the control, touch and hold the 9
and 0 pads at the same time for 3
seconds. The display will show LOCOFF.
When this feature is on, the touch pads will not
respond except for the Clear/Off pad.
The adjustment will be retained in memory
after a power failure.
11