Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
Temperature setting
• Each time the temperature setting button A is pressed once,the temperature
setting changes one time. After the temperature setting has been completed,
the refrigerator will run according to the set value after 15s.
• When Super Cool mode is activated, the fridge will run at its maximum
capacity to faster reach the coolest setting and lasting longest for 6 hours.
The shift regulation is:
Note: The temperature of each gear is within
situation is slightly different according to the load situation.
Fault indication
•
When electrify the refrigerator fot first time, the display screen shines fully
for 3 seconds, and then the refrigerator runs according to normal. In case of
a failure, the corresponding LED blinks. In case of no failures, it shows the
temperature setting of refrigerator.
Fault Code
Lock/Unlock
• When the temperature control panel is in lock state, it needs to long press
temperature setting key for 3 seconds for unlocking the panel, all LEDs will
blink for 2 seconds when panel is unlocked. When the temperature control
panel is in unlock state, if there is no operation on control panel within 15
seconds, it will enter into lock state automatically.
Damper adjusting slider
• The temperature inside the freezer can be adjusted by changing the position
of the damper slider.The initial position of the damper slider is at position A.If
lower temperature inside the freezer is required, you can adjust the damper
slider from the position A to left side.
Max setting position
Note: For better use of the refrigerator , it is recommended to keep the damper slider at
initial position.Shelf humidity control
(normal)
c of the set temperature, and the actual
Fault Description
Refrigerator temperature sensor faults
Freezing frost sensor faults
Ambient temperature sensor failure
COLDEST
13
Damper Slider
A
COLD
EN
Publicidad
