Kärcher Chariot CV 60/1 RS Manual Del Usuario página 51

Code Description of Code
Drive Motor Unknown Motor Controller
17
18 Brake Detect Error
Drive Motor External Temperature
19
Sensor Error
1A Drive Motor Open Circuit
1B Drive Motor Overheat
1C Vacuum Motor Short
1D Vacuum Motor Low FET Error
1E Vacuum Motor High FET Error
Vacuum Motor Internal Motor
1F
Controller Error
Vacuum Motor Unknown Motor
20
Controller Error
21 Vacuum Motor Overcurrent Error
22 Vacuum Motor Open Circuit
23 Clogged Hose, Hopper, or Bag
24 Actuator Overcurrent
25 Traction Motor DMC Over Temperature
26
Brush Motor DMC Over Temperature
Side Broom Motor DMC Over
27
28 Vacuum Motor DMC Over Temperature
Error
Temperature
8.644-716.0 Manual Operator Chariot CV60/1 RS
Corrective Actions –
If the problem persists, call for service
Disconnect power with the main breaker, remove the brush
tray and clean the brushes.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Locate the traction motor circuit breaker and reset..
Allow the traction motor cool down for 1 hour before
continuing operation
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Disconnect power with the main breaker, remove the side
broom and clean.
Locate the side broom circuit breaker and reset.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Locate the vacuum motor circuit breaker and reset.
Change the vacuum bag.
Inspect the vacuum hose and hopper and clear any clogs.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Maintenance
51