Kärcher Chariot CV 60/1 RS Manual Del Usuario página 52

Maintenance
Error Codes Table, cont.
Code Description of Code
Traction Motor DMC Temperature Error
29
Brush Motor DMC Temperature Error
2A
Side Broom Motor DMC Temperature
2B
Vacuum Motor DMC Temperature Error
2C
Serial Number Error - Missing Serial
2D
Lithium Battery CAN Communication
Error - Battery CAN Module
2E
Unplugged, Installed Backwards, or
Received too many Errors in a Short
2F
Contactor Error (Welded) - Damaged
30
Contactor Error (Open) - Damaged
31
32 Brush Motor Open Circuit
33 Brush Motor High Voltage Protect Error Locate the brush motor circuit breaker and reset.
Side Broom Motor High Voltage
34
Protect Error
35 Drive Motor High Voltage Protect Error
Vacuum Motor High Voltage Protect
36
Error
37 CAN1 Failure
52
(FET)
(FET)
Error (FET)
(FET)
Number
damaged.
Amount of Time.
Contactor
Contactor
8.644-716.0 Manual Operator Chariot CV60/1 RS
Corrective Actions –
If the problem persists, call for service
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Disconnect power with the main breaker.
Remove the side broom and clean.
Remove the brush tray and clean the brushes.
Allow the controllers to cool down for 1 hour before
continuing operation.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Locate the Lynk module inside the left hand door. Ensure
that the green light is on and it is connected on either end.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Locate the brush motor circuit breaker and reset.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Ensure that the grade is appropriate for the machine.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.
Turn the main breaker off and wait 10 seconds before
turning it back on.