Publicidad
Idiomas disponibles
Idiomas disponibles
Renfert GmbH
9.2
Set up the unit
ü Unpack the unit completely.
ü Keep the cover and accessories, e.g. basket, inserts, etc. on hand.
◦ Place the unit on the selected surface.
IMPORTANT The controls, such as the rotary knobs and buttons, must be clearly visible and easily
accessible.
è The unit has been installed.
9.3
Connect the unit
Connecting the power cord
ü Ensure that the required power connection is available.
1. Plug the power cord into the IEC connector on the unit.
2. Route the power cord in such a way that it does not pose a tripping hazard, cannot be damaged
and is not exposed to moisture. The power cord must not touch the unit housing, as the housing
becomes hot during operation.
3. Connect the plug. The plug must be easily accessible so that it can be disconnected in emergen-
cies.
è The power supply has been connected.
10
Fill the tank
Suitable cleaning liquids for ultrasonic cleaning are:
• Water
• Softened water
• Distilled water
Cleaning power can be improved by adding aqueous cleaning agents. See Dosing cleaning agent [} 16].
ü The unit and the tank are clean and, if necessary, disinfected.
ü The recommended tank operating capacity for the relevant unit sizes is stated in the technical data.
See Technical data [} 9].
ü The unit is ready to use.
1. Add the fluid to the tank up to the fill level marking using, for example, a measuring jug. The fill level
marking is the stacking collar (1).
CAUTION! An overfilled tank can cause the cleaning fluid to boil over at high
temperatures.
Easyclean TEC
1
Fill the tank
15 / 24
Publicidad
