Publicidad
Idiomas disponibles
Idiomas disponibles
Renfert GmbH
15.1 Replace the network cable
ü The network cable or plug contacts are visibly damaged.
◦ Replace damaged network cables immediately.
NOTE! Removable network cables may not be replaced with insufficiently measured
network cables!
è The network cable has been replaced.
15.2 Clean enclosure
ü The enclosure is dirty.
ü The network cable is unplugged.
◦ Wipe all surfaces using a damp cloth.
WARNING! Do not spray the outside of the unit with water.
è The enclosure has been cleaned.
15.3 Cleaning the tank
ü The tank is full of limescale or dirty.
ü The tank is empty.
1. Use a damp cloth to wipe out limescale and dirt residue. If necessary, rinse the tank using a shower
set.
CAUTION! Do not spray the unit with water from the outside and never submerge it in
water.
ðThe tank has been cleaned.
2. To descale the tank, fill it with tap water up to the fill level marking in the tank.
3. Heat up the unit to 40 °C.
4. Add Renfert GO2011 Speed following the manufacturer's instructions.
5. Once 40°C has been reached, switch off the unit.
ðLeave to work as per manufacturer's instructions.
6. Then, switch on eco ultrasound mode for approx. 15 min.
7. Empty the tank.
8. Use a damp cloth to wipe out the remaining limescale and dirt residue. If necessary, rinse the tank
using a shower set.
CAUTION! Do not spray the unit with water from the outside and never submerge it in
water.
è The tank has been descaled and cleaned.
Easyclean TEC
Maintenance
23 / 24
Publicidad
