Publicidad
Content of the EC declaration of conformity (with reference to point 1.7.4.2, letter c) of directive
2006/42/EC)
With reference to annex II, part 1, section A of directive 2006/42/EC, the declaration of conformity
accompanying the machinery contains:
1. the business name and full address of the manufacturer and, where applicable, its authorised
representative;
See the first page of the manual
2. name and address of the person authorised to compile the technical file, who must be established
in the Community;
It coincides with the manufacturer, see the first page of the manual
3. description and identification of the machine, including generic name, function, model, type, serial
number, trade name;
See the first page of the manual
4. a statement explicitly declaring that the machinery is in conformity with all the relevant provisions
of this directive and, where appropriate, a similar statement declaring conformity with other
community directives and/or relevant provisions with which the machinery complies. These
references must be those of the texts published in the Official Journal of the European Union;
The machinery must comply with the following applicable Directives:
2006/42/EC
5. where appropriate, the name, address and identification number of the notified body which carried
out the EC type‐examination referred to in annex IX and the number of the EC type‐examination
certificate;
N/A
6. where appropriate, the name, address and identification number of the notified body which
approved the full quality assurance system referred to in annex X;
N/A
7. where appropriate, reference to the harmonised standards referred to in article 7, paragraph 2,
which have been applied;
UNI EN ISO 12100:2010
8. where appropriate, reference to other standards and technical specifications applied;
N/A
9. place and date of declaration;
Sasso Marconi,
10. identification and signature of the person authorised to draw up the declaration on behalf of the
manufacturer or its authorised representative.
The Managing Director of Ravaglioli S.p.A. Mr Giulio Curreli
/
/
0435-M002-1
Machinery Directive
S afety of machinery ‐ General principles for design ‐ Risk
assessment and risk reduction;
5 9
Publicidad
