Bosch Professional GSH 14 C Manual Original página 15

Operation
Starting Operation
Pay attention to the mains voltage! The voltage of the
u
power source must match the voltage specified on the
rating plate of the power tool. Power tools marked
with 230 V can also be operated with 220 V.
Products that are only sold in AUS and NZ: Use a resid-
u
ual current device (RCD) with a nominal residual current
of 30 mA or less.
Status indications
Power tool status indicator Meaning
(user interface) (9)
– Power tool switched off
Green Power tool switched on and ready to use
Yellow Warning message
Red Error message
Flashing blue Power tool is connected to a mobile device via
Bluetooth
or
settings are being transferred
Pulsing red The Rest reminder function is activated (via
app) and is indicating that you are due a
break.
The Rest reminder settings can be configured in the app.
Maintenance indicator (user Meaning/cause
interface) (12)
Lit up orange Regular power tool maintenance is due soon. Send the power tool to the after-sales service
– in combination with the
power tool status indicator
(user interface) (9) being
lit
Flashing orange Regular power tool maintenance is now due.
– in combination with the
power tool status indicator
(user interface) (9) being
lit
Selecting the working mode
– Press the button for selecting the High-power and Low-
power working modes until the working mode you require
lights up.
Bosch Power Tools
Switching On and Off
– To start the power tool, push the on/off switch (2) into
position "I".
– To switch off the power tool, push the on/off switch (2)
into position "0".
At low temperatures, the power tool will take a certain
amount of time to reach its full impact performance. You can
shorten this warm-up time by tapping the power tool's inser-
ted application tool on the ground once.
User Interface (see figure C)
The user interface (3) is used to select the working mode
and to indicate the status of the power tool.
®
– The High altitude mode is activated/deactivated in the
app.
Solution
–
–
Read the message on the smartphone
Read the message on the smartphone
–
Terminating the Rest reminder function:
– Switch off the power tool and leave it
switched off for at least 10 minutes
or
– Pull the mains plug from the plug socket
– Reset the Rest reminder function via the
app
Solution
Switch off the power tool immediately and
send it to the after-sales service
1 609 92A 7FT | (12.01.2023)
English | 15