Carat P Serie Instrucciones página 21

Warning of rotating tool!
Running direction of the
saw blade
Wear gloves. Wear ear
protectors. The machine
meets EU guideline.
Observe the operating
manual. Wear protective
goggles
Main pillar safety
device
Laser class: II
Wavelength: 635 nm
Laser
Class 2
Warning!
635 mm
ATTENTION
Do not stare into beam!!
DO NOT
STARE
INTO
BEAM
3. MACHINE DATA
3.1 Diamond blades
DANGER!
Risk of injury by defective or incorrectly mounted
diamond blades!
Wrong rotation direction and damaged diamond blades
may cause injuries of personnel!
Check diamond blades for broken off segments and
segment pieces, segment foot cracks, diamond blade
deformations or signs of wear before starting work.
Pay attention to the rotation direction arrows on the
diamond blades and guard!
DANGER!
Risk of injury by unchecked or unapproved tool!
Diamond blades or buzz saw blades that have not been
checked or approved may cause injuries of personnel!
Before starting work, check whether a proper diamond
blade is mounted.
Pay attention to the rotation direction arrows on the
diamond blade and guard!
NOTE!
All diamond blades used must be designed in
terms of their permissible max. cutting ¬speed¬ to match
the max. drive speed and intended application of the
machine tool
Diamond blade Diameter Material
Tile and natural Ø 350 mm Ceramics,
stone Carat stoneware, tiles,
blade marble, granite
Universal Carat Concrete,
blade washed
concrete, bricks,
clinker, hard
stone, granite
Concrete Carat Hard stone,
blade granite, natural
and artificial
stone, hard
clinker
Brick and Brick and
asphalt Carat asphalt
blade
3.2 Type plate
The type plate is located on the base frame of the machine
tool.
3.3 Installation site requirements
The floor surface must:
- Have sufficient load bearing capacity.
- Be slip proof.
- Be level.
3.4 Storage requirements
Storage conditions
As a matter of principle, the machine, its components,
assemblies or parts must be only stored in the following
conditions:
do not store outdoors. store in dry and dust-free place.
do not expose to aggressive media. protect from
solar radiation. avoid mechanical vibrations. storage
temperature range 5 to 45°C
relative air humidity, max. 60%. In case of storage for
over 3 months, check general condition of all parts and
Arbor hole
25,40 mm
21