Carat P Serie Instrucciones página 87

Error message / error
High segment wear!
Diamond blade shows side
and radial run-out
Zero performance when
cutting, diamond blade
is blunt
Suboptimal blade
Mounting bore of the
diamond blade is worn out
Possible cause Troubleshooting
Segment bonding is Use cutting wheels with
too soft harder seg ments or reduce
feeding pressure
Segments are too thin Reduce the feeding
in relation to the mo tor pressure , or use cutting
capacity and feeding wheels with thicker
pressure segments
Segment number is too Use cutting wheels with seg-
small ments, or reduce the feeding
pressure
The cutting wheel runs Use a new cutting
out wheel , have the old one
straightened , check the
cutting shaft , use a new one
if necessary
The cutting wheel Check the table guides,
deviates replace if necessary
Abrasive aggregates Use cutting wheels with
harder seg ments
Feeding pressure is too Reduce the feeding pressure
high
Diamond blade is bent or Have the diamond blade
damaged straightened, solder the
segments to a new blade or
use a new blade
Flange is polluted or Clean or replace the flange
damaged
Motor shaft is Replace the electric motor
bent
The diamond blade does Use a proper diamond blade
not match the material
The diamond blade does
not match the machine
capacity
The diamond blade is
too hard
Diamond on the segment sharpen
are blunt
Blunt segments sharpen
Diamond blade is Use an appropriate diamond
overloaded blade
Poor tension of diamond Return the cutting blade
blade
The diamond blade Check the mounting flange,
rotates on the motor shaft replace if necessary
The mounting bore must
be hollowed out and a ring
fitted in
Personnel
Operating personnel
Manufacturer
Operating personnel
Qualified electricians
Operating personnel
Specialist personnel
Specialist personnel
Operating personnel
Manufacturer
Manufacturer
Specialist personnel
87