Carat P Serie Instrucciones página 22

packaging on a regular basis. If necessary, renew or replace
conservation materials.
4. TRANSPORT
ATTENTION!
Damage through improper transportation!
Improper transportation can result in considerable damage
of the machine and objects in the vicinity.
Before every transport:
- The cutter head must be locked.
- The cutter head must be lowered and locked.
- The cutting table must be secured by the table lock
(for table saw machines).
- The machine must be disconnected from power supply.
- - The legs of the machine must be closed.
Due to two transport rollers, the machine can be
transported by one or two persons who can use transport
handles.
Note
Never move the machine by dragging. Always use
the intented wheels.
Instruction of using crane lifting eyes
The machine is designed for crane transport by means of
the lifting eye.
Always check the tighteness of the lifting eyes before using
it to transport the machine. To avoid damage, also check
that the lifting straps do not touch the motor when lifting.
CAUTION:
Risk of injury due to improper handle when it is
transported by crane.
22
CAUTION:
Risk of injury by standing under the machine when
it is transported by crane.
CAUTION:
Risk of injury of falling material from the working
table, it is not allowed to have any material on working
table when it is transported.
Crane lifting eyes P-3515 / P-3520
P-3510 / P-3512 / CARACOUP 104 ALU / CARACOUP 100 ALU
5. INSTALLATION
5.1 Connection
Before connecting the machine to the power source,
make sure that:
- Voltage / phase of the power supply, match the date on
the type plate of the motor and machine.
- The power supply line is grounded according to the safety
provisions.
- The wire size of the extension cord is sufficient, H07RNF
3x2.5 mm² up to 100m for 230V.
5.2 Mounting a diamond blade
To mount a new diamond blade or replace the used one,
proceed as follows:
1. Switch off the machine and interrupt the power supply
by pulling the mains cable from the mains outlet.
2. Loosen the screws on the diamond blade guard so as to
be able to remove the front half of the diamond blade
guard.
3. Loosen the nut of the arbor hole and remove the outer
cutter flange.
4. Clean the cutter flange, nut and motor shaft.