Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Error message/
Response of Magnet
Button
Indicator lights up green Magnetic holding power possibly
Indicator flashes green
Indication flashes red for
approx. 2 seconds
Indication lights up red
for approx. 2 seconds
when the motor is
switched off
Indicator lights up red
continuously
Indicator flashes red
continuously
Repair and customer service.
When working metal under extreme oper-
ating conditions, it is possible for conductive
dust to settle in the interior of the power
tool. The total insulation of the power tool can be
impaired. Blow out the interior of the power tool via
the ventilation slots frequently with dry and oil-free
compressed air.
Renew stickers and warning indications on the power
tool when aged and worn.
After several hours of operation, the play in the dove-
tail guide can increase. As a consequence, the drill
motor can glide alongside the dove-tail guide by itself.
In this case, retighten all set screws of the dove-tail
guide correspondingly so that the drilling motor can
easily be moved manually, yet does not glide by itself
(see page 18/19).
Meaning
sufficient.
Magnetic holding power possibly
insufficient.
Overload of motor.
Motion sensor has actuated.
Magnetic foot cannot be
switched off sooner than 2
seconds after the motor has
been switched off.
Incorrect mains voltage or mains
frequency.
A button or switch is already
pressed upon plugging in the
power supply cord.
Power tool is defective.
Corrective Action
Always secure the machine with the supplied safety
strap.
Always secure the machine with the supplied safety
strap.
When working on steel materials where the
material thickness is below 12mm, the work piece
must be made thicker with an additional steel plate
in order to ensure the magnetic holding power.
After malfunction correction, the power tool can
be switched on again.
Pay attention that the set-up surface for the
magnetic foot is flat, clean, rust-free and ice-free.
Remove varnish, putty/filler layers and other
materials.
Prevent an air gap between the magnetic foot and
the set-up surface. The air gap reduces the magnetic
holding power.
Do not use the machine on hot surfaces, as this
could result in a permanent reduction of the
magnet holding power.
After malfunction correction, the power tool can
be switched on again.
Wait until the red LED goes out and the green LED
lights up or flashes.
Unplug the machine, correct the error and plug in
the power supply cord again. If the error message
is still present, send the machine to your FEIN
customer service agent.
Send the machine to your FEIN customer service
agent.
When the machine's power supply cord is damaged, it
must be replaced by the manufacturer or their repre-
sentative.
Products that have come into contact with asbestos
may not be sent in for repair. Dispose of products con-
taminated with asbestos according to the applicable
country-specific regulations for such disposal.
en
33
Publicidad
