Maintenance And Cleaning; Wear Parts - Oase OptiMax 85i Instrucciones De Uso

- EN -
Dry installation
OptiMax 250/285
NOTE
The pump is not self‐priming and must be
installed below the level of the water.
How to proceed:
C
• Pull off the filter housing.
• Fit Suction connection
• Fit the bayonet closure and lock into place.
• Fit the hose on the pressure side. (→
Technical data)
• Fit the hose on the suction side. (→
Technical data)
• Fit the pump to the outside of the
aquarium using the suction cups to ensure
that it cannot move out of position.
COMMISSIONING/START‐UP
C
• Route the power connection cable such
that it forms a drip loop!
• Switching on: Connect the unit to the mains.
The unit switches on immediately.
• Switching off: Disconnect the unit from
the mains.
10

MAINTENANCE AND CLEANING

If necessary, clean the unit with clear water
using a soft brush.
• Do not use cleaning agents or chemical
solutions.
Replacing the impeller unit
D
• Dismantle the filter housing, or bayonet
closure and pressure socket.
• Remove the impeller unit, clean or
replace.
• Reassemble the unit in the reverse order.

WEAR PARTS

The following components are wear parts
and are excluded from the warranty:
• Suction cups, impeller unit
OptiMax 85i/85/135i/135/250/285