Brother LS2-B877 Manual De Instrucciones página 121

Problem
7. Upper thread trimming
errors (-305)
8. Lower thread trimming
errors (-305)
9. Lower thread is tangled at
the sewing start.
Lower
thread
Spinning of bobbin
during thread
80%
trimming
(-305)
•
Is the timing correct during thread trimming?
Adjust the timing for thread trimming.
•
Are the tips of the movable knives damaged or bent?
Replace the movable knife which is damaged.
•
Is there too much clearance between the tips of the movable knives and
the rotary hook stoppers?
Adjust so that the clearance is 0.05 - 0.2 mm.
•
Is the tension release mechanism working correctly?
Adjust the tension release mechanism.
•
Are the tips of the movable knives in the correct positions?
Adjust the positions of the movable knives.
•
Are the tips of the movable knives too low?
Are the tips of the movable knives damaged or bent?
Replace the movable knife which is damaged.
•
Are the rotary hooks too high?
Push the rotary hooks down to install them correctly.
•
Is the bobbin spinning direction correct when the lower thread is being
pulled?
Set the bobbin so that it turns in the opposite direction to the rotary
hook.
•
Is there too much thread wound onto the bobbin?
The bobbin winding amount should not be more than 80%.
•
Is the anti-racing spring attached?
Attach the anti-racing spring.
•
Is the bobbin turning smoothly?
If the bobbin is not turning smoothly, replace the bobbin.
•
Is a bobbin other than the light-alloy bobbins specified by Brother being
used?
Use only bobbins which are specified by Brother.
LS2-B877, LT2-B878 (English)
15. TROUBLESHOOTING GUIDE
15. FEHLERSUCHE
15. RECHERCHES DE PANNES
15. GUIA PARA LA LOCALIZACION DE FALLAS
Where to check Page
71
76
78 · 89
67
78 · 81
76
92
29 · 30
26
28
29 · 30
28
102