John Bean T2545T Manual Del Operador página 35

iii-1
FOR ELECTRIC MOTOR POWERED VERSION ONLY:
Connect the machine to the air supply with a rubber
hose (rated for the pressure) with an inside diameter of
6 mm (1/4"). A ¼" NPT fi tting is provided at the air inlet.
FOR AIR MOTOR POWERED VERSION ONLY:
Connect the machine to the air supply with a rubber
hose equipped with 3/8" treaded junction.
WARNING! THE AIR LINE MUST BE 3/8" OR LARGER.
SMALLER SUPPLY LINES WILL CAUSE LOW
PERFORMANCE.
BEFORE CONNECTING THE MACHINE TO THE AIR
SUPPLY BE SURE THAT NOTHING IS LEFT ON THE
TURNTABLE AREA (TOOLS,ETC).
After ensuring all the above proceed as follows:
• Connect the machine to the air supply (max. pressure
of 12 bar - 170 psi) with a rubber hose (rated for the
pressure) with an inside diameter of 6 mm (1/4") (Fig.
iii-1).
• To install any accessory on request follow the
instructions enclosed with it.
• In case of installation of an air-fi lter and lubricator,
check correct functioning.
Pneumatic hose connection check
When fi rst setting the machine into operation, check hose
connections and unions for leakage.
iv Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
• Show the operator how to switch the unit on and off.
35
EN -