INSTALLATION INSTRUCTIONS
Control panel
Remotable auxiliary keyboard [code : QUIX-TST]
The keyboard is connected to the
inverter with an hexapolar cable ( max 2m)
whose shield is ground connected on the
inverter side
Menu selection key:
It allows to scroll through the
parameter sets:
d-xx, F-xx, P-xx, b-xx, C-xx
Enter key:
- it goes to the Selected
Parameter
Confirmation of the
-
set value
Removable keyboard
[code QUIXF-TST]:
Caution: the changes made to parameter values have an immediate effect but are not
automatically stored. The storage is performed through the C- 00 control.
(*) NOTE: the flashing of Green Leds indicates the action of the motor stall or inverter fault
prevention.
• • • • •
The display is used to show both letters and numbers, e.g.:
P P P P P -xx means:
xxx.x
means:
• • • • •
The parameter sets, or MENUS, have the following meaning:
d d d d d -xx
menu of the read-only parameters ( display )
F F F F F -xx
menu of the read/write parameters of the terminal board selectable frequencies
P P P P P -xx
menu of the read/write parameters
b b b b b -xx
menu of the read/write parameters, ON/OFF type ( they can be changed with a stopped motor
only)
C-xx
menu of control-type parameters
12-GB
Green Led:
Green Led:
forward run (*)
backward run (*)
FFD
REV
FWD
M
E
1
2 3
4 5
Fwd
Rev
Prg
M
E
P = letter indicating the selected menu
xx = numeric code indicating the parameter progressive number
number, also decimal, indicating the value of the selected parameter
—————— SIEI ——————
Yellow Led:
If flashing, the change has not
been stored permanently
PRG
H z
H z
H z
H z
H z
A A A A A
V V V V V
RESET
6
The Leds and the Keys of the
Extractable Keypad have the same
meaning and perform the same
functions of the Auxiliary Keyboard,
with exception of the indication of
the unit of measures.
!
"
Decrease Key:
- it selects the parameter inside a
menu
- it decreases the parameter value
Decrease Key:
- it selects the parameter inside
a menu
- it increases the parameter
value