mspa Lite LS042-NA Manual Del Propietário página 10

6
Make sure the filter cartridge remains in place when the spa is
filled with water.
NOTE: It is recommended to fill the spa with lukewarm water for quick heating and energy saving. Using tap water for spa filling to minimize the influence of
unwanted content, such as minerals.
NOTE: Ensure the manometer points to the Green section when the spa is filled with water.
WARNING:
Do not drag the spa after filling it with water.
Do not operate the spa until the water reaches the Minimum line.
The water temperature should not be higher than 40°C / 104°F.
NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
Make sure the cover, and mostly its side facing water, will not come into contact with the ground or any other dirt when not in use.
Covers shall be cleaned inside and out periodically using a suitable solution that includes adequate disinfection (e.g. 10ml/l of free Chlorine).
CONTROLLER OPERATION
°C LED display
°F
Once powered-up, press the RESET on the PRCD. The LED displays the current water temperature automatically.
NOTE: The actual water temperature may vary from the temperature displayed on the LED screen by as much as approximately 1°C.
Buckle Lock Operation
LED Display
Heater Button
Bubble Button
Up Button
7
°C
°F
HEATER FILTER
BUBBLE TIMER
UP DOWN
10
Lock
Filter Button
Timer Button
Down Button
Unlock