Garland GAS 409 XE Manual De Instrucciones página 31

Remember to always use the machine with clean
hands and without petrol and oil.
Clean the working area and remove any obstacles
that could cause accidents. Check the workplace and
remove all elements that could be at risk of being
propelled from the workplace towards other people.
Do not allow anybody to enter the working area.
This working perimeter is 15 metres and this is a
dangerous zone.
Never use the machine when on top of a ladder, in a
tree or in any other unstable surface.
When moving from one working area to the next, turn
off the engine.
Never let the machine unattended.
Do not use any accessories that are not originals and
that have not been recommended by the manufacturer.
Use of other accessories can cause accidents and can
be dangerous for the end user and those nearby as well
as causing damages to the machine.
Always follow the security rules that we indicate in the
manual.
7.1. HOW TO HOLD THE MACHINE AND GUIDE IT
WHILST WORKING
Hold the blower with the
handle in your right hand
as shown in the figure.
7.2. SPEED REGULATION
This machine has a speed regulator
with which you can control the flow of
blown or sucked air. To regulate the
speed, turn the speed regulator up or
down depending on whether you want to have more
or less speed.
7.3. WORKING WITH THE BLOWING
Always follow the security stipulations that we indicate
in the manual.
Start the machine with the machine on the ground,
place it on your back and aim the air flow towards
the leaves and materials to be pushed. Push all the
material towards one place which preferably should
be a corner.
7.4. AFTER USAGE
Once you stop using the machine.
1. Disconnect power to the machine by moving the
switch to the "OFF" position.
2. Unplug the machine.
3. Clean the remaining material from the tubes.
8. MAINTENANCE AND SERVICE
Carry out random inspections on the machine to
ensure an efficient use of the machine. For a
complete maintenance take the machine to your
nearest service agent.
Never attempt to carry out any maintenance work
on the machine if the machine is running. Carry out
all maintenance work on a flat surface and on a clear
surface.
Always carry out all the maintenance work with
the machine unplugged from the mains.
Read the instruction manual before carrying out
any maintenance work.
31/112
English