EINHELL GC-EH 4550 Manual De Instrucciones Original página 10

or the like along the hedge so that you cut the
hedge to a level height. Cut off all branches
which protrude beyond the guide line (see
Figure 5).
•
Cut the sides of the hedge with curve-shaped
movements from the bottom up (see Figure
6).
7. Replacing the power cord
Danger!
If the power cord for this equipment is damaged,
it must be replaced by a special power cord which
is available from the manufacturer or a service
center.
8. Cleaning and maintenance
HAZARD!
Always remove the power plug from the power
source before starting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The ingress of
water into an electric power tool increases the
risk of an electric shock.
8.2 Servicing
•
The blades should be cleaned and lubricated
at regular intervals in order to ensure best
performance at all times. Remove deposits
with a brush and apply a thin film of machine
oil (see Figure 7).
•
There are no other parts inside the equipment
which require maintenance.
Anl_GC_EH_4550_SPK7_USA.indb 10 Anl_GC_EH_4550_SPK7_USA.indb 10
EN
9. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 41°F and 86°F
(5°C and 30°C). Keep the electric tool in its
original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 10 -
13.12.2022 12:55:34 13.12.2022 12:55:34