Publicidad
A
WAR: NIN G
Electrical Shock or Personal Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
. Unplugged at wall outlet.
1. Plug in firmly. Push ON-OFF
Cleaner will
not run.
switch to ON.
. Tripped thermal protector.
2. Reset thermal protector.
. Push ON-OFF switch to ON.
. ON-OFF switch not turned on.
. Tripped circuit breaker/blown
fuse at household service panel.
. Reset circuit breaker or replace
fuse.
Poor job of dirt
. Full or clogged dust bag.
pickup.
. Change bag.
. Agitator On-Off selector in
wrong position.
2. Set in the correct position.
. Clogged hose or nozzle.
. Clean hose or nozzle area.
. Hose not inserted fully.
, Insert hose.
. Worn agitator.
. Replace agitator.
. Hole in hose.
6. Replace hose.
. Dust cover improperly installed.
Properly install dust cover.
. Tripped agitator overload
protector.
Agitator does
Reset agitator overload protector.
not turn.
. Tripped agitator thermal protector.
Reset agitator thermal protector.
This is normal. Agitator will not
. Vacuum in full upright position.
rotate in full upright position.
. Agitator On-Off selector in
. Push selector to ON.
off position.
. Property install bag.
Dust escapes
the paper bag.
. Bag improperly installed.
2. Bag torn.
2. Replace bag.
Light will
1. Burned out light bulb.
1. Replace light bulb.
not work.
1. Clean optic cells.
Dirt sensor will
1. Dirty optic cells.
not work.
-20 -
Publicidad
