Sunrise Medical Oxford Hoyer Arise Manual De Instrucciones Y Garantía Para El Usuario página 4

6
3.
Tighten the mast assembly with the mast-locking device, which is located at the
front of the chassis.
Avoid trapping fingers. Keep fingers away from the end of the mast when
inserting into the chassis socket. Full engagement of the mast is indicated
by the label on the side of the mast. The electric leg operation will not func-
tion unless the mast is fully engaged.
4.
Turn the locking knob until hand tight.
5.
Line the handle assembly up to the rear of the mast, and attach using the fixings
provided. The fixings and wrench needed to attached the handle are kept in the
user instruction wallet for safe keeping.
NOTE– When attachingthe handle to the mast be sure that all trailing wires are left outside
the handle beofre fixing.
6. Fit power pack to the lift and make sure the latch holding the pack in place is fully
engaged. "Click" in place.
DISASSEMBLY
The lift should not be disassembled unless for service, repair or transport if necessary.
Therefore follow the assembly instructions in reverse sequence.
294000.10008 Rev. C
E n g l i s h
WARNING
E n g l i s h
ALWAYS CHECK THE FOLLOWING BEFORE OPERATION
• The mast is fully locked into position.
• The legs of the lift open and close satisfactorily (This is done via the hand control).
• The red emergency stop button, located on the rear of the control box, is in the OFF
(out) position.
• Push the up and down buttons on the hand control and confirm the boom rises and
lowers.
7
294000.10008 Rev. C