Description; Intended Use; Residual Risks; Overview - GreenWorks Pro CS60L03 Manual Del Operador

EN
1

DESCRIPTION

1.1

INTENDED USE

This chainsaw is designed for cutting branches, trunks, logs
and beams of a diameter determined by the cutting length of
the guide bar. It is only designed to cut wood.
It is only to be used in an outdoor, domestic application by
adults.
Do not use the chainsaw for any purpose not listed above.
This chainsaw is not to be used for professional tree services.
It is not to be used by children or by persons not wearing
adequate personal protective equipment and clothing.
1.2

RESIDUAL RISKS

Even with the intended use of the power tool, there is other
risk which cannot be prevented.
According to the type and construction of the power tool, the
following potential hazards might happen:
• Contact with exposed saw teeth of the saw chain (cutting
hazards).
• Access to the rotating saw chain (cutting hazards).
• Unforeseen, abrupt movement of the guide bar (cutting
hazards).
• Flung out parts from the saw chain (cutting / injection
hazards).
• Flung out parts of the work piece.
• Inhalation of work piece particles.
• Skin contact with the lubricating oil.
• Loss of hearing, if no ear protection is used during work.
1.3

OVERVIEW

Guide bar cover
1
English
Front handle guard /
2
chain brake
Front handle
3
Lock out button
4
Trigger
5
Oil tank cap
6
Oil indicator
7
Bucking spikes
8
Chain
9
2 GENERAL POWER TOOL
SAFETY WARNINGS
WARNING
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your battery-
operated (cordless) power tool.
2.1

WORK AREA SAFETY

• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases or
dust. Power tools create sparks which may ignite the dust
or fumes.
• Keep children and bystanders away while operating a
power tool. Distractions can cause you to lose control.
2.2

ELECTRICAL SAFETY

• Do not expose power tools to rain or wet
conditions.Water entering a power tool will increase the
risk of electric shock.
2.3

PERSONAL SAFETY

• Stay alert, watch what you are doing and use common
sense when operating a power tool. Do not use a
power tool while you are tired or under the influence
of drugs, alcohol or medication. A lapse of attention
while operating power tools may result in serious
personal injury.
• Use personal protection. Always wear eye protection.
Protective products such as dust mask, non-skid safety
shoes, hard hat or hearing protection used appropriately
will reduce personal injuries.
• Prevent unintentional starting. Ensure the switch is in
the off position before connecting to power source
and/or battery pack and when picking up or carrying
the tool. Carrying power tools with your finger on the
switch or energizing power tools that have the switch on
invites accidents.
• Remove any adjusting key or wrench before turning
the power tool on. A wrench or a key left attached to a
4
10 Guide bar
11 Wrench
12 Rear handle
13 Chain tension screw
14 Chain cover
15 Chain cover nuts