Mase Generators I.S. 16 Manual De Instalación página 21

GENERATORS
6.4. Generator - Mains switching
A switch should be placed on the line to switch the user
appliances from the generator to an external power line.
The switch should be dimensioned according to the size
of the loads: a general diagram is shown in fig.18.
7 HANDLING
For handling and lifting of the generator only use the lifting
hook located on the engine.
Hooking the generator at points different from that
indicated may cause damage to the generator or be
dangerous to the operators.
8 WIRING DIAGRAM REFERENCES
See Fig.19
1 - Magnetothermal switch
2 - Hour counter
3 - Alternator
4 - Rotor
5 - Stator
6 - Voltage regulator
7 - Power terminal board
8 - Insulators
9 - Thermal switch
10 - START / STOP- button
11 - Engine protection module
12 - Terminal board
13 - Connector for remote control panel connection
14 - Fuel level gauge
15 - Oil pressure gauge
16 - Water temperature gauge
17 - High water temperature sensor
18 - High coolant temperature sensor
19 - Oil pressure switch
20 - Battery charger alternator
21 - Stop electromagnet
22 - Starter motor
23 - Battery connection terminals
24 - Panel connection cable
25 - START / STOP- button
26 - Oil pressure gauge instrument
27 - Coolant temperature gauge instrument
28 - Remote control panel kit with instruments
29 - Remote control panel kit
GB
- 21 -
IS 12-14-16-19