Hart VJC607S-C-3701 Manual Del Operador página 10

OPERATION
with a float valve that stops the suction action
when the collection tank reaches its maximum
capacity. You will notice an increase in motor
speed. When this happens, turn off the machine,
disconnect from power supply, and drain the liquid
into a suitable receptacle or drain. To continue
vacuuming, refit the power head to the collection
tank. After wet vacuuming, turn the machine off
and remove plug from power supply. Empty the
collection tank, clean and dry the inside and
outside before storage.
REMEMBER! The foam wet filter must be
removed after wet vacuuming and the cartridge
filter must be installed before dry vacuuming again.
FIG. 24
FIG. 25
FIG. 26
FIG. 27
FIG. 28
FIG. 29
BLOWER OPERATION
See Figures 30-36.
This wet/dry vacuum has blowing capabilities.
To use the blower feature follow the instructions
listed.
WARNING:
Always wear safety goggles complying with ANSI Z87.1
(or in Canada, CSAZ94.3) before using blower.
WARNING:
Keep bystanders clear from blowing debris.
WARNING:
Wear a dust mask if blowing creates dust that might
be inhaled.
10 English