Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
WARNING:
Do not plug the power cord into a power outlet. Make
sure the plug is disconnected before assembling the
wet/dry vacuum. To reduce the risk of electric shock,
do not expose to rain.
UNPACKING YOUR WET/DRY VACUUM
See Figures 3-5.
• Verify that the power cord is disconnected from
the outlet.
• Undo the latches.
• Lift the power head off the collection tank.
• Remove the contents from inside the collection
tank; make sure you have all contents as listed
on page 5.
FIG. 3
FIG. 4
FIG. 5
ATTACHING THE CASTERS
See Figure 6.
• Turn the collection tank upside down and insert
the four casters into the slots on the collection
tank. Verify that the casters are mounted
correctly.
LATCH
1
2
POWER HEAD
6 English
ATTACHING THE HANDLE
See Figure 7.
• Attach the handle into the slots located on the
top of the power head and secure with supplied
screws.
INSTALLING THE CARTRIDGE FILTER
See Figures 8-9.
• Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not installed,
refer to page 13 for installation instructions.
FIG. 6
FIG. 7
FIG. 8
FIG. 9
CASTER
CARTRIDGE
FILTER
Publicidad
