Bosch PR10E Instrucciones De Funcionamiento Y Seguridad página 20

BM 2609140306 09-05
attachment to remove routing dust and debris
for enhanced utility, visibility and accuracy.
The dust collection capability of the PR007
can be used in both common types of router
applications:
1. Routing on flat surfaces
2. Edge-forming
To reduce the risk of
!
WARNING
injury, do not reach in area
of the bit while the router is ON or
plugged in. To avoid entangling hoses, do
not use this dust extraction hood at the
same time as any other dust extraction
hood.
Dust Extraction when Routing on
Flat Surfaces
Attach the dust port on the back end of the
subbase.
1. Position the port on the backside of
subbase
PR008 BASE COVER
(Included with PR004 Offset Base. Also
available as optional accessory)
The optional PR008 Base Cover (Fig. 34) is
available to provide insulation from tool heat
in continuous and/or high-usage applications.
It can be used on the PR001 Fixed Base,
PR005 Tilt Base, and PR004 Offset Base
(with which it is standard equipment).
Installation of Base Cover
1. Remove clamp.
2. Slide cover over the top of the base and
into position
3. Reattach clamp. Make sure that washers
sit on outside of cover.
10/5/05 8:12 AM Page 20
2. Affix using two thumbscrews included.
Dust Extraction when Edge-forming
Attach the dust hood and port on the back
end of the subbase.
1. Position the hood on the backside of
subbase
2. Position the port on the backside of the
dust hood.
3. Affix using two thumbscrews included.
Vacuum Hose Compatibility
The dust port is sized to accept 35mm
vacuum hoses. The PR007 includes the
VAC002 adapter that will allow the port to be
connected to 1-1/4" and 1-1/2" vacuum
hoses. An adapter to connect the hood to 2-
1/2" hoses is also available separately.
FIG. 34
Remove
Clamp
-20-
Base
Cover