Publicidad
Idiomas disponibles
Idiomas disponibles
Remote Control Function and Instructions
1. Install battery:open the battery cover which is in the remote control,
install two pieces of AAA (1.5V)(#7)dry batteries, pay attention to the
polarity of battery before installing. Put on the battery cover and use
screws to fix. (Please follow the steps above to replace the battery.
Only adults can replace it. Please don't mix the new and old batteries
or different batteries. Please take away the exhausted batteries from
the toys in time.)
Loosen a screw
2. use method:
a. use for the first time needs to match code. This product has storage
function. Replace battery or restart don't need to match code.
b. Press "▲"&"▼"keys for 3 seconds at the same time to start match
code, the first LED flickers.
c. Turn the car body power on now, the first LED lit up, match code
succeeds.
d.Press remoter for 10 seconds if it doesn't run it will be stand by,
press any key wake it up.
e.Keys caption: "▲" Forward, "▼" Back, "
"S"Speed, "P" Brake.Press "S" key to accelerate(1 LED lit up is low
speed, 2 LED lit up is medium speed, 3 LED lit up is high speed).
Back a car is only low speed. Press"P"key hold the brake, all LED
flicker.
22
Load two AAA(1.5V) batteries
" Left, "
" Right,
Forward
Speed
Back
WARNING！
1. Not for children under 3 years old. Small parts. Choking hazard.
2. The remote controller only can be used with adult's guidance.
3. Load two AAA(1.5V )batteries according to the diagram.
4. Non-rechargeable batteries are not to be recharged.
5. Different types of batteries or new and used batteries are not to be
mixed.
6. Batteries are to be inserted with the correct polarity.
7. Exhausted batteries are to be removed from the toy.
8.The supply terminals are not to be short-circuited.
9. Should take away the exhausted batteries from the toys, and
handle well, prevent played by children and caused harm.
10. The packaging must be retained since it contains important
information.
Charging steps are as follows
Step1:The charging hole is under the seat.
Step2: Put the charger plug into the plug hole.
Step3: Connect the charger to the power socket.
Brake
Right
Left
Speed Display
23
Publicidad
