Publicidad
Idiomas disponibles
Idiomas disponibles
Install front wheel
Install rear wheel
1. Remove the nuts (2pcs) from the rear axle (50cm/19.5").
2. Passing the rear axle through the body,make sure rear axle is
positioned evenly on each side. Install the drive motors "L" and "R" on
the left and right side of the rear axle respectively.
3. Place a bushing on the inside of the wheel. Align the wheel driven
connector with the screw hole of wheel,use 3pcs M4*12mm round
head screws to fix.(total installed two wheels according to these steps)
4. Slide a wheel with driven connector onto the rear axle, place a M12
washer and finally fix it with a nut. Snap on a wheel cap. Repeat on
the other side. NOTE:Use two plastic wrenches(one on each side)
and rotate in opposite directions to tighten nuts.
14
1. Remove the nuts(2pcs) from
the front axle.
2. Insert the washer, bushing,
wheel and washer in turn through
the front axle (bushing aligned
with the inside of the wheel) and
secure with the nut. Finally snap
nut
on the wheel cap.
1. Flip the car onto its wheels, within the seat,plug the connectors for
the left and right drive motors into the designated terminals on the
circuit board.
2. Insert the connector from the battery into the designated terminal on
the circuit board.
NOTE: Make sure the connector is oriented correctly to fit into the
terminal.
nut
Connect the motor wiring and power cord
Install tractor connection
1. Insert the tractor connection
into the rear of the car, at the
bottom of the seat, and secure it
with 2pcs 4*35mm flat head
screws.
15
Publicidad
