Publicidad
Free-arm
Sewing
• For free-arm
sewing:
1. Grip the extension table with your index finger and thumb.
2. Pull gently to the left. The extension table wilt snap out.
• For flat-bed
sewing:
1. Insert the tab and the pin into their catches.
2. With your thumb and index finger, gently snap in.
Changing
Needle
_1_Needle clamp screw
Needle clamp
[]
Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise,
toward you, and lower the
presser foot.
Loosen the needle clamp screw _1_by turning it
counterclockwise.
Remove the needle from the ctamp_.
[]
Insert a new needle into the needle clamp _ with the fiat
side to the rear.
When inserting the needle into the clamp, push it up as
far as it goes. Tighten the clamp screw _ firmly by turning
it clockwise.
[]
To check for a good needle, place the fiat side of the needle
onto something fiat (needle plate, glass,etc.) The gap
between the needle and the flat surface should be consis
tent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags
or runs in knits, fine silks and silk-like fabrics.
Changing
Presser Foot
(_l_Lever
(_Groove
_Pin
[]
To remove:
Turn the handwheel toward you to raise the needle to its
highest position. Press the lever_t_on the back of the foot
holder. The presser foot witl drop off.
[]
To attache:
Place the presser foot so the pin (_ on the foot lines just
under the groove _ of the foot holder. Lower the foot
holder to lock the foot in place.
18
/
[]
[]
s
[]
Flat side
Lade piano _
Needle
M6plat vers
Aguja
Aiguille
[]
I
I
!
[]
Publicidad
