Publicidad
Button Sewing
Stitch selector:
B to C
Stitch length:
Any
Needle thread tension: 1 to 4
Presser foot:
Zigzag foot
Feed dogs:
Dropped
c
®
PATTERN: C
®
LENGTH:
ANY
Drop the feed dogs. (See p. 42)
1. Set the stitch selector at" B "
2. Match the holes on a button with the horizontal slot of
the zigzag foot and place the left hole of the button just
below the needle point.
3. Lower the foot and turn the stitch selector to zigzag until
the needle point comes just above the right hole of the
button.
4. Sew about five stitches then raise the needle.
5. Set the stitch at" B "again and sew a few stitches to
lock thread.
To strengthen the shank, cut the threads leaving about
4"(10 cm). Bring the needle thread down through one of the
holes on the button and wind it around the shank.
Bring the needle thread to the wrong side (Bottom side) of
fabric and knot. After button sewing is completed, raise the
feed dogs for normal sewing.
/
66
Publicidad
