Publicidad
English
The WH-10 is an optional hanging bracket for attaching the printer to a wall. This manual
describes the procedures and precautions for installing and using the WH-10.
Applicable Printer Models
This WH-10 can be used only with the products specified below. Please note that the use of
products other than those specified may result in improper installation and operation.
❏
TM-T88IV/TM-T88V/TM-T88VI/TM-T88VII
❏
TM-T88IV/TM-T88V/TM-T88VI/TM-T88VII with the OT-BX88/OT-BX88V/OT-
BX88VI/OT-BX88VII power supply cover
❏
TM-U220B/TM-U220D with the Serial numbers xxx030000 or later. (xxx depends on the
model.)
❏
TM-U230
❏
TM-T90
❏
TM-L90
Precautions
❏
To use the TM-T88IV/TM-T88V/TM-T88VI/TM-T88VII on the wall, be sure to attach the
connector cover to the printer.
❏
To prevent paper jams and to insure the print density level, do not use 3-sheet roll paper
with the TM-U220.
❏
Static electricity may cause cut paper to adhere to the printer case.
(This static electricity will not affect the operation of the printer.)
Unpacking
Open the package and confirm that it contains all of the parts listed in the illustration. If any parts
are missing or damaged, please contact your dealer for assistance.
❑ Wall-mount
*Note: Screws for wall-mount are not
included.
❑ Control panel sheets
•
For TM-T88IV
•
For TM-T88V
•
For TM-U220
*Note: Control panel sheets for the
TM-T90, the TM-L90, and the TM-U230
are packed with the printer.
2 WH-10 Installation Manual
Wall Hanging Bracket Set
WH-10
Installation Manual
❑ Brackets (2 pieces)
❑ Screws for brackets
×
(3
12) (4 pieces)
❑ Roll-paper stopper for TM-T88IV
❑ Roll-paper stopper for TM-T88V/
TM-T88VI/TM-T88VII
❑ Installation manual
Publicidad
