Publicidad
Changing the Roll-paper Near-end Detector Position and Paper Width
(Only for the TM-U220)
Two types of screws are used with the WH-10: 3×6 and 3×10. The longest screw (3×12) will not
be used.
1. Open the printer cover (roll paper cover).
For a model that does not have a roll-paper near-end detector and does not need a change in
paper width, jump to step 7. For a model that does not have a roll-paper near-end detector and
needs a change in paper width, jump to step 3.
2. Loosen the detector adjustment screw a little bit by using a tool such as a coin and then loosen
the screw gently by hand as until it stops. It must not be removed completely.
3. Remove the 2 screws of the roll paper guide.
For a model that does not have a roll-paper near-end detector, jump to step 6.
4. Rotate the detector lever on the roll paper guide to change its direction.
Note:
After the direction of the detector lever is changed, be sure that the cable is connected to the
connector firmly.
Detector lever
5. Tighten the detector adjustment screw.
Roll paper
guide
WH-10 Installation Manual 5
English
Detector adjustment screw
Cable
Publicidad
