Publicidad
English
Attaching the Roll-paper Stopper (Only for the TM-T88IV/TM-T88V/TM-T88VI/
TM-T88VII)
1. Cut off the roll-paper stopper.
Left side
2. Open the printer cover (roll paper cover).
3. Align the 2 projections on the roll-paper stopper with the holes in the printer, and push them
into place. For the TM-T88V/TM-T88VI/TM-T88VII, align the projections with the holes,
and rotate the roll-paper stoppers toward the printer back until they click.
Note:
For the TM-T88V/TM-T88VI/TM-T88VII, make sure the position of the stepped parts on the
top of the roll-paper stoppers are aligned with that of the projections on the roll paper holder (for
58 mm paper width, on the roll paper guide).
TM-T88IV
Changing the Roll-paper Detector Position
(Only for the TM-T88IV/TM-T88V/TM-T88VI/TM-T88VII and the TM-T90)
1. Loosen the screw for the detector.
2. Push the lever on the detector until it touches the back of the hole.
3. Turn the knob toward you until the lever clicks into place in the other hole.
4. While settling the knob by pressing the knob toward you, secure the screw.
Detector lever
4 WH-10 Installation Manual
Right side
cut
For TM-T88IV
Projection on the
roll paper holder
Knob
Left side
For TM-T88V/TM-T88VI/TM-T88VII
TM-T88V/TM-T88VI/TM-T88VII
Stepped part
Right side
cut
Projection on the
roll paper guide
58 mm paper width
Detector screw
* This installation example is for the
TM-T88IV.
Publicidad
