Publicidad
English
6. Align the hole on the roll paper guide with the hole on the roll paper holder to match your roll
paper width and then tighten the screw (3×10).
Note:
You will not use one of the two screws that have been removed when the roll paper guide is
removed. Please store it as an extra screw in case you need it.
Roll paper
guide
7. Align the hole on the roll paper holder for hanging bracket with the dowel on the roll paper
guide. (For a model that needs a change of paper width, the hole to be used will be different to
match your roll paper width.)
Putting the screw (3 × 6) in the hole on the roll paper holder for hanging bracket makes it
easier for you to tighten the screw in the next step.
Dowel
8. Tighten the screw (3 × 6) to fix the roll paper holder for hanging bracket and the base frame.
6 WH-10 Installation Manual
76 mm
58 mm
70 mm
76 mm
70 mm
Roll paper
holder
58 mm
Roll paper holder for
hanging bracket
Hole
Publicidad
