EN
•
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
•
Do not use a battery pack or product that is damaged or modified. Damaged or modified batteries may
exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
•
Do not expose a battery pack or product to fire or excessive temperature. Exposure to fire or temperature
above 130 °C (265°F) may cause explosion.
•
Follow all charging instructions and do not charge the battery pack or product outside the temperature
range specified in the instructions. Charging improperly or at temperatures outside the specified range may
damage the battery and increase the risk of fire.
Maintenance and service
•
Be sure the product is powered off before performing any maintenance or when installing or replacing parts.
•
Follow all instructions contained in the manual when performing maintenance on the product.
•
Do not use high-pressure hose to clean the product.
•
Have your product serviced by a qualified repair person using only identical replacement parts. This will ensure
that the safety of the product is maintained.
•
Never service damaged battery packs. Service of battery packs should only be performed by the manufacturer or
authorized service providers.
•
Store the product in a location where it is protected from the elements whenever possible. Ultraviolet light from
the sun can fade the paint and can cause rubber or plastic parts to become porous or to crack.
SAVE THESE INSTRUCTIONS
2.3
FCC REQUIREMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE
FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT AND ITS
WARRANTY.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
3
ASSEMBLY
This section describes how to assemble and adjust the
product.
CAREFULLY READ AND UNDERSTAND THE
SAFETY CHAPTER AND THE ASSEMBLY
INSTRUCTIONS BEFORE YOU ASSEMBLE THE
PRODUCT.
English (Original Instructions)
WARNING
WARNING
3.1
INSTALL THE STEERING WHEEL
1. Attach the steering wheel to the steering column.
8