Publicidad
Idiomas disponibles
Idiomas disponibles
2. Insert the M6 bolts and M6 nuts in Bag A into the
steering wheel mounting holes.
3. Use the No.10 open-end wrench to fix the nuts,while
using the No.5 hex key to securely tighten the bolts.
4. Attach the steering wheel cap by snapping into
place at the center of steering wheel.
3.2
INSTALL THE SEAT
1. Insert the two barbs, located under the seat, into the
two slots, on the frame.
English (Original Instructions)
2. Pull up and hold the seat lever to move the seat to
its frontmost position, exposing the mounting holes
at the rear.
3. Insert two M8 x 40 mm flange bolts and M8 nuts in
Bag B through the mounting holes. Use the T-socket
wrench to fix the nuts, while using the No.13 open-
end wrench to securely tighten the bolts.
3.3
INSTALL THE BELT
1. Attach the end of the belt to the frame and use a
bolt, washer, gasket, and nut to secure it in place
(as shown in the figure). Repeat this step on all
eight anchorage points.
9
EN
Publicidad
