Publicidad
e) Touch the icon (i) for 3 seconds. Indicator will light up.
f) Indicator of the icon will flash.
g) Touch the icon (i) icon again to accept the selection. The descaling process will begin and
the icon (i) will remain flashing.
Along the process, water will flow out at intervals through the steam and coffee outlet
nozzles.
h) After a certain time (about 18 minutes), the indicator of the icon (j) will light up.
Take the water tank out, empty and fill it with fresh water up to the maximum level. Insert
the water tank into the coffee maker. Make sure it is fitted correctly.
2. Second stage: rinsing the water circuit
a) Touch the icon (i). Descaling process will continue.
b) Once cleaning process has finished, all the indicators of the icons will light up perma-
nently. The coffee maker is ready to be used again.
NOTE: If the descaling process is interrupted, touch the (i) icon again. Descaling process
will continue automatically from the same point previous to the interruption.
NOTE: time counter for next descaling will be reset only after the process is completed
without interruptions.
5.5 Cleaning the water tank
Regularly rinse the water tank for properly maintenance.
1. Remove the water tank (6). Take it from the handle (8) and pull it out.
2. Wash the water tank under the tap.
3. Insert the water tank into the coffee maker. Make sure it is fitted correctly.
5.6 Cleaning the milk frother
Milk frother must be cleaned after each use.
1. Insert the milk frother into a cup or container with hot water.
2. Touch the Power icon (a) to switch the coffee maker on. Wait until automatic rinsing
process is finished.
3. Touch the icon (d) once. Indicator will light up.
4. Touch the icon (d) again: Steam preparation will start.
5. Keep the frother into the hot water for some seconds. Then, dry the frother with a damp
cloth.
63
Publicidad
