Publicidad
Idiomas disponibles
Idiomas disponibles
22
CAUTION RISK OF DAMAGE! DO NOT ALLOW SPRAY PATTERN
TO REMAIN ON A FIXED AREA FOR AN EXTENDED PERIOD OF
TIME. POSSIBLE DAMAGE MAY OCCUR TO THE AREA.
10. Your pressure washer can deliver high pressure spray and a variety of spray
patterns using cold water. If you wish to use the hot water application or
cleaning with detergents for the correct procedures.
11. When finished, follow the SHUTDOWN procedure.
HOT WATER OPERATION:
1. Follow the steps outlined for "COLD WATER OPERATION".
2. Press UP and release the Burner Switch to place the unit in Hot Water
mode. On initial start-up, water will begin turning hot in approximately 60
seconds and will reach maximum temperature in approximately 3 minutes,
provided the trigger remains squeezed. The burner will stop firing when
the trigger is released.
3. Set thermostat to the desired setting.
WARNING RISK OF BURN! THE WATER TEMPERATURE COULD
BECOME VERY HOT DURING HOT WATER OPERATION.
CAUTIOUS WHEN ADJUSTING PRESSURE OR CONTROLLING
THE TRIGGER GUN/DUAL LANCE ASSEMBLY.
4. When finished, follow the SHUTDOWN procedure.
At this point, the unit is operating as a hot water pressure washer. Be cer-
tain to be extremely cautious when adjusting the pressure and controlling
the trigger gun/dual lance assembly to avoid the possibility of burns.
NOTE: The burner is equipped with a safety lock-out device. If the pilot
fails to ignite within 60 seconds, the gas valve locks OFF. Simply
release the trigger for approximately another 60 seconds and repeat.
During operation, the burner may cease and start occasionally be-
cause of the thermostat setting.
IMPORTANT WHEN COLD WATER IS BEING PUMPED INTO THE
HEAT EXCHANGER AND THE BURNER IS ON, CONDENSATION
MAY FORM ON THE COIL AND DRIP. THIS WILL GIVE THE
APPEARANCE OF A LEAKING COIL PARTICULARLY IN COLD
HUMID WEATHER.
CLEANING WITH DETERGENTS:
This feature is designed for use with mild detergents only. Since the clean-
ing solution travels through the heat exchanger coil, do NOT use corrosives
as the will cause extensive damage as well as pose a considerable safety
hazard.
1. Be certain to wear protective safety attire.
2. Prepare detergent solution according to label directions. (Never pump
acids, alkalines, abrasive fluids, or solvents through the unit.)
3. Fully immerse the strainer end of the clear vinyl detergent hose into the
detergent solution.
4. Press UP on the Detergent Switch to place the unit in detergent mode.
Adjust the amount of detergent desired by turning the detergent adjustment
knob to the desired setting.
5. To apply a solution, unlock the trigger gun and squeeze the trigger. In a few
moments a detergents/water mixture will exit the nozzle. Start spraying
the lower portion of the surface being cleaned and move up, using long
overlapping strokes. Applying from the bottom up helps avoid streaking.
Allow to soak briefly. Avoid working on hot surfaces or in direct sunlight to
minimize the chances of the detergent drying, which may result in damaging
surfaces. Be certain to clean a small section at a time.
PLC OPERATING INSTRUCTIONS
BE
Operator's Manual
Publicidad
