Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLEPLATE IS
Connection problem
NOT HEATING
EVEN THOUGH
Temperature control is in MIN position
IRON IS TURNED
ON.
IRON DOES NOT
Not enough water in tank
PRODUCE STEAM
Steam control is selected in non-
steam position.
Selected temperature is lower than
that specified to use with steam.
SPRAY
Not enough water in tank
FUNCTION DOES
NOT WORK
STEAM JET AND
Steam jet function was used very
VERTICAL STEAM
frequently within a short period.
JET FUNCTION
Iron is not hot enough
DOES NOT WORK
THE IRON
The temperature setting is too low to
LEAKING
produce steam.
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electri-
cal and electronic waste collection centre closest to your home.
We hope that you will be satisfied with this product.
20
Solution
Check main power supply cable, plug
and outlet.
Select adequate temperature
Fill water tank
Set steam control between positions
of minimum steam and maximum
steam (see"iron chart").
Select a higher temperature
Fill water tank (see "getting started",
no 2).
Put iron on horizontal position and
wait before using steam jet function.
Adjust to higher temperature to steam
ironing. Put iron in vertical position
and wait temperature indicator light
turns off.
The variable steam knob must be set
on"0"position until the iron is hot.
Publicidad
