Brother 888-X73 Manual De Instrucciones página 21

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
While lightly holding the thread, turn the
6
needle threader lever toward the front of
the machine (toward you). The hook will
pull the thread through the needle.
Raise the needle threader lever.
7
Pull the loop of the thread passed through
8
the eye of the needle toward the rear of
the machine.
1 Loop of thread
CAUTION
Be careful not to pull on the thread with
●
force or it may bend the needle.
If the thread does not pass through the
●
eye of the needle, start from step
again.
Raise the presser foot lever.
9
0
1
3
Pass the end of the thread through the
presser foot, and then pull out about 5 cm
(2 inches) of thread toward the rear of the
machine.
1
1 5 cm (2 inches)
Note
● If you incorrectly feed the thread you may
cause sewing problems.
1
20