Publicidad
Idiomas disponibles
Idiomas disponibles
SEWING BASICS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
2
SEWING BASICS
Please read before sewing
CAUTION
To avoid being injured, watch the needle carefully while you are using the machine. Keep
●
your hands away from moving parts.
Do not stretch or pull the fabric during sewing, otherwise the needle may be damaged and
●
you may be injured.
Do not use bent or broken needles, otherwise you may be injured.
●
Take care that the needle does not hit basting pins or other objects during sewing. The needle
●
may break and you may be injured.
Always use the correct presser foot. If you use the wrong presser foot, the needle may hit the
●
presser foot and bend or break and you may be injured.
When you turn the handwheel by hand, always turn it toward you (counterclockwise).
●
Turning it the other way may cause the thread to tangle and damage the needle or fabric, and
you may be injured.
Do not start sewing without placing the fabric under the presser foot, otherwise the presser
●
foot may be damaged.
Starting sewing
Turn on the machine.
1
CAUTION
Do not turn on the machine while pressing
●
down the foot controller. The machine
may start unexpectedly and cause
personal injury or damage to the machine.
Raise the needle by turning the
2
handwheel toward you
(counterclockwise) so that the mark on
the wheel points up.
Turn the pattern selection dial to select a
3
stitch (see page 11).
Change the presser foot (see page 10).
4
23
Raise the presser foot lever.
5
1 Presser foot lever
Place the fabric under the presser foot,
6
pass the thread under the presser foot,
and then pull out about 5 cm (2 inches) of
thread toward the rear of the machine.
1
1 5 cm (2 inches)
1
Publicidad
