Descargar Imprimir esta página

Upright AB-46 I/C Manual Del Operador página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

Leveling the Platform
DO NOT operate the machine if the platform
does not maintain level when elevated.
Note: Platform leveling can be performed only with the
boom stowed and should be done only to calibrate the
automatic leveling system.
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, push the platform
level control switch forward to swing the platform
upward, rearward to swing the platform downward.
Release the switch to stop leveling.
Rotating the Turret
1. Set the function speed control dial to the desired
setting. Rotate the dial clockwise to increase speed,
counterclockwise to decrease. If you are not sure what
speed to use, start out slow; the speed can be varied
while operating the function.
2. While depressing the foot switch, turn the turret
rotation control switch counterclockwise to rotate left,
clockwise to rotate right. Release the switch to stop
rotation. Observe the area around the boom when
rotating the turret to avoid any obstructions.
Elevating the Riser
1. While depressing the foot switch, push the riser
control lever forward to elevate the riser, rearward to
lower the riser. Release the control lever to stop
elevating / lowering. The riser will function at a con-
stant speed, function speed control setting is not
necessary.
Elevating the Upper Boom
1. Set the function speed control dial to the desired setting.
Rotate the dial clockwise to increase speed, counter-
clockwise to decrease. If you are not sure what speed to
use, start out slow; the speed can be varied while
operating the function.
2. While depressing the foot switch, push the upper boom
control lever forward to elevate the upper boom, rearward
to lower the upper boom. Release the control lever to stop
elevating / lowering.
Extending the Upper
Boom
1. While depressing the foot switch, push the boom
extension control lever rearward to extend the boom,
forward to retract the boom. Release the control lever to
stop extending / retracting. The boom extension will
function at a constant speed, function speed control
setting is not necessary.
Elevating the Jib
1. Set the function speed control dial to the desired setting.
Rotate the dial clockwise to increase speed, counter-
clockwise to decrease. If you are not sure what speed to
use, start out slow; the speed can be varied while
operating the function.
2. While depressing the foot switch, push the jib control
lever forward to elevate the jib, rearward to lower the jib.
Release the control lever to stop elevating / lowering.
Rotating the Platform
1. Set the function speed control dial to the desired setting.
Rotate the dial clockwise to increase speed, counter-
clockwise to decrease. If you are not sure what speed to
use, start out slow; the speed can be varied while
operating the function.
2. While depressing the foot switch, turn the platform
rotation control switch counterclockwise to rotate left,
clockwise to rotate right. Release the switch to stop
rotation.
6

Publicidad

loading