Publicidad
Idiomas disponibles
Idiomas disponibles
EXISTING CONSTRUCTION (JOIST/ ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
1. Perform one of the following steps based on the
installation type:
a. If there is an existing fan in place, remove the
existing fan and ensure the opening in the
ceiling is large enough for the new fan.
b. If there is not an existing fan in place, choose
the location in the ceiling and cut an opening
according to the size of the template (I).
Ensure one edge of the opening aligns with
the edge of the joist.
2. Connect the round duckwork (not included) to
the duct adaptor (E) and secure with duct tape
(not included) or clamps (not included).
3. Connect the wiring according to the wiring
diagram.
a. Connect the black wire from the fan to the
black wire from the fan wall switch
with two-port
quick connect (FF).
b. Connect the black wire from the light to the
black wire from the light switch
with two-port
quick connect
(FF).
c. Connect the white wire from the fan to the
white wire from the light and connect to the
line in from the ceiling
with three-port quick
connect (GG).
d. Connect the ground/green wire from the unit
to the ground bare wire in the ceiling
with two-
port quick connector
(FF)
.
e.
Use the wire housing screw (EE) to screw the
wire housing cover (B).
Note: For single wall switch applications, remove
and cut the clear 2 port connectors from the
2 black wires coming from the bath fan
chassis. Strip 1/2 in. of insulation from the
wire ends and connect both black wires to
the single black wire coming from the ceiling/
switch.
Hardware Used
•
Wire Housing Screw
X
1
10
(FuTILITECH'
)
Lowes
.com
l:l
- · -
Publicidad
