Publicidad
Idiomas disponibles
Idiomas disponibles
EXISTING CONSTRUCTION (JOIST/ ABOVE CEILING ACCESS APPLICATION) INSTALLATION
INSTRUCTIONS
4.
Strip 1/2 in. of insulation from wire ends. Grip the
wire firmly and push the stripped end of the wire
into the open port of two-port quick connect (FF) or
three-port quick connect (GG). Use only one
stripped end of the wire per port. Verify the stripped
end of the wire is fully inserted to the back of two-
port quick connect (FF) or three-port quick connect
(GG).
Hardware Used
G
Two-port Quick connect
B
x
3
~
Three-port Quick connect
B
x 1
5. Place two clips (BB) along the bottom edge of each
side of the housing (A). Place the housing (A) into
the opening, then mount the housing (A) to the joist.
Note: The clips (BB) will ensure the bottom edge of
the housing (A) is flush with the ceiling board.
Hardware Used
•D
Clip
x4
11
house
house wires
~
~
UTILITECH'
]
Lowes
.com
i.:J,I
- ·
-·
Publicidad
