Publicidad
Idiomas disponibles
Idiomas disponibles
EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
1. Perform one of the following steps based on the
installation type:
a. lfthere is an existing fan in place, remove the
existing fan and ensure the opening in the ceiling is
large enough for the new fan.
Use the template (I)
provided to determine if the existing hole in the
ceiling is large enough for this new fan to be
installed. You may be required to make the hole
larger to match the size of the template (I)
provided.
Note:
If the existing hole from the previous fan is
larger than the template (1), the hole must
be made smaller to match the template (I)
provided.
b. lfthere is not an existing fan in place, choose
the location in the ceiling and cut an opening
according to the size of the template (I).
Ensure one edge of the opening aligns with
the edge of the joist.
2. Insert the housing (A) at an angle through
the ceiling opening and temporarily place the
housing (A) above the existing ceiling.
Note:
For access from below installation, you must have at
least 8 inches of clearance between sub floor and
ceiling for the fan's chassis to fit properly.
13
r
[m UTIUTECH"
)
Lowes. com
~
-~-
Publicidad
