Descargar Imprimir esta página

Husqvarna K1270 II R Manual De Usuario página 20

Ocultar thumbs Ver también para K1270 II R:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
Problem
The product has no power when the
operator tries to throttle up.
The vibration levels are too high.
The temperature of the product is too
high.
The engine decreases in power or in
speed.
Transportation and storage
For storage and transportation of the product and
fuel, make sure that there are no leaks or fumes.
Sparks or open flames, for example from electrical
devices or boilers, can start a fire.
Always use approved containers for storage and
transportation of fuel.
Empty the fuel tank before you put the product in
storage for a long period of time. Discard the fuel at
an applicable disposal location
Safely attach the product during transportation to
prevent damage and accidents.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Keep the product in a dry and frost free area.
Disposal
Obey the local recycling requirements and applicable
regulations.
Discard all chemicals, such as oil or fuel, at a service
center or at an applicable disposal location.
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
20
Cause
The air filter is clogged.
The fuel filter is clogged.
The fuel tank flow is blocked.
The cutting blade is installed incor-
rectly.
The cutting blade is defective.
A vibration damping unit is defective.
The air intake or the cylinder flanges
are blocked.
The drive belt tension is not suffi-
cient.
The clutch is defective.
The air filter is clogged.
Transportation, storage and disposal
Possible solutions
Examine the air filter. If it is necessa-
ry, replace it.
Replace the fuel filter.
Speak to your service agent.
Make sure that the cutting blade is
correctly installed and that it is not
damaged.
Replace the cutting blade and make
sure that it is not damaged.
Speak to your service agent.
Clean the air intake and the cylinder
flanges.
Examine the belt. Adjust the tension.
Always cut at full throttle.
Examine the clutch. Speak to your
service agent.
Examine the air filter. Refer to
amine the air filter on page 18 .
1390 - 001 - 10.01.2020
To ex-

Publicidad

loading

Este manual también es adecuado para:

K 1270 r