Winkhaus blueMatic EAV Instrucciones De Montaje página 168

Installation, Operating and
Maintenance Instructions
EN
Teaching wireless remote controls directly via the receiver
4
• If the programming is performed via the receiver, this will have to be freely
accessible.
• Press the P1 button of the receiver until the green LED lights up.
• Release the button.
• Activate the desired button of the remote control while the LED is lit up
• As long as the LED is lit, you can program additional remote control buttons.
Display memory full: The memory has been filled to capacity (max. 85 buttons),
if the teach-in button of a new wireless remote control is used and both LED
displays of the receiver flash simultaneously.
Deleting wireless remote controls directly via the receiver
Partial deletion
• Press and hold the P1 button of the receiver until the green LED lights up.
• Release the button.
• Press the button of the wireless remote control while the LED is lit up.
• A programmed wireless remote control will be deleted automatically.
• A wireless remote control that has not been programmed by this method
will need a programming (analogue "Teaching-in of wireless remote controls
directly via the remote control").
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMatic EAV 74 5044744
No. Name
P1 button
green LED
red LED
Buzzer
Relay
Jumper 12 V / 24 V