SUHNER ABRASIVE SMH 60-HT XL Documentación Técnica página 17

2.1.3 d /c
etAching onnecting the collet chuck
Remove tool or clamping pin (see 2.1.2).
Unscrew the cap on the cable so that the electronic com-
ponents are displayed.
1
Insert the collet chuck key (1) into the collet chuck and
lock the collet chuck shaft with the locking key (2). Loosen
the collet chuck by turning it anti-clockwise. Reassemble
by following these instructions in reverse, ensuring that
you tighten the collet chuck without using excessive force,
insert the tool or clamping pin and turn the handle until
you hear an audible click to show that it has locked into
place.
Never tighten chuck collets without a tool or
clamping pin.
2.2 r
Ating dAtA
Power Input
Max. torque
Max. speed
Collet chuck EMA
Noise level at 50'000 min -1
Vibration EN 60745
Insulation class
Weight
Dimensions Diameter of 30mm x lenght 200mm
2.3 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3.1 w
To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure. Exces-
sive pressure lessens the working capability of the hand
tool, as well as the life of the grinding tool.
3.2 s
Hold the hand tool firmly. Switch on the control unit.
hand tool must always be held in your hand. Switch OFF
the control unit when work has been finished. The tool will
continue to run for a while after the hand tool has been
switched OFF. Put the hand tool down safely, so that no
hazards can occur.
2
4.1 p
4.2 s
See page 2-3.
4.3 r
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.4 w
In the event of the tool being improperly handled, used
max. 280W for purposes for which it is not intended and/or of the ser-
8.9Nm vice and maintenance instructions not being observed by
1
50'000 min- non-authorized persons, no warranty shall be in effect for
2.35mm / 3 mm / 1/8" damages/consequential damages. Complaints can only
59.8dB(A) be honored if the hand tool is returned in the undisas-
2 2
<2.5m/s , K=1.3m/s sembled condition.
IP54
4.5 s
0.400kg
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C
3. h
aNDlINg
orking instructions
on/off
witching
Perform a test run where the tool runs without load
for at least thirty seconds. Do not use the grinding
tool if it is vibrating. When it is in operation, the
4. S /m
ERvIcE
reVentiVe mAintenAnce
Always keep the hand tool clean and in a dry
place. Worn collet chucks must be replaced.
pAre pArts
epAir
ArrAnty
torAge
/o
PERaTIoN
aINTENaNcE
17